A short dip in boiling water and the head will soften and pop right off. Repeat the process to put it on another neck. The head will harden back up." -- Don Thompson
"On the question of hard heads, a hair dryer also will work and doesn't get the figure wet." -- bcsnaare@pinn.net
Here's how to take off the head of an action man snow board raider (IAM). Simply grab the head and pull upward until it comes off. Putting another head on works the same way, only you push. Sometimes, if the head is hard, warming it with a hair dryer makes it soft and easier to put on/take off. I have done this four or five times and never damaged anything. Don't worry about the little pin. -- Bob S.
I have used the unorthodox method of heating hard heads in the microwave starting at about 10 seconds on high and increasing the time in 2-3 second increments on stubborn heads. You do have to be careful or you will melt them. -- RRG-Zach-La
I have used the unorthodox method of heating hard heads in the microwave starting at about 10 seconds on high and increasing the time in 2-3 second increments on stubborn heads. You do have to be careful or you will melt them. -- RRG-Zach-La
If you want to trade the heads with someone, do it with the posts. It is easy to change the post. Simply lift it up and slip a small screw driver or ice pick into the elastic hole to hold it in place, then just slip the post off the hook. If you insist on taking the head off the post, then use some warm (hot) water to soften the head. -- Matthew
For more of this article CLICK HERE
GI Joe® is a trademark of Hasbro, Inc.
GI Joe® is a trademark of Hasbro, Inc.
0 (mga) komento:
Mag-post ng isang Komento